As we were in class getting ready for the competition tomorrow, we
were asked for our robots name, and we then realised that we did not have one,
and after a few minutes, we came up with the name "The Clunker".
We felt that this name could describe our robot well, because of its
appearance.
Bishop Allen Academy Grade 12 Physics - Sumo Robot Challenge - THE CLUNKER!
December 14, 2011
December 11, 2011
December 10, 2011
December 9, 2011
Wiring Of The Clunker
Today, we started all the wiring
and finished off the moving robot. We started with the 2 switches
connecting to the power and to the two motors. Next we moved onto wiring the
battery, which we did have, an issue at first. We did not connect the batteries correctly, resulting
in the motor moving very slowly. We then realized that the motors
were only running off 1 battery, which was 6v, rather than all three battery's
which was 18v total.
December 3, 2011
December 1, 2011
Building The Frame of The Clunker
We gathered all
the pieces that we needed, we then began to build at James's house.
We decided to start off by building the base, which was easy after we made the
correct measurements. Next, we drilled out all the holes needed, and sawed off
the excess wood. We encountered one
problem, with mounting the wheels onto the motor shaft because our measurements
were off, so the wheels were shaking on the shaft. We also installed the front
wheels onto body. Later we began the wiring for the controller, and started
the wiring from the battery's to the motors and to the remote.
November 24, 2011
Brainstorming
We began brainstorming on possible ideas for out Sumo Bot. We listed all the part and materials that we would need to build out bot. A problem that we got stuck at was what we would use for wheels, because we would want something with traction and not slide easily, but not too big. Once we had the list of required materials needed, we divided the list and agreed to get the materials by out next meet.
Subscribe to:
Posts (Atom)