December 1, 2011

Building The Frame of The Clunker


We gathered all the pieces that we needed, we then began to build at James's house. We decided to start off by building the base, which was easy after we made the correct measurements. Next, we drilled out all the holes needed, and sawed off the excess wood. We encountered one problem, with mounting the wheels onto the motor shaft because our measurements were off, so the wheels were shaking on the shaft. We also installed the front wheels onto body. Later we began the wiring for the controller, and started the wiring from the battery's to the motors and to the remote.

No comments:

Post a Comment